I had the same thing and I decided to shut down Erae and resume without any problem.
Thanks for your reply Jean-Marc. Another person had recommended that I remove the SD card and then re-boot the Erae2, and this did work. EraeLab 1.5.4 does report that the Erae2 has now been updated to FW 1.0.8.
One big sticking point for me now is that I still can only save to project slot #1 on the Erae2. I really need access to all 8 save slots so that I can start using the Erae2 as intended.
Marc Langelier
For the last half an hour, my Erae 2's screen just reads:
"Finishing Install
This will take
a minute"
What now? Should I turn the Erae2 off and then back on again, or will this screw up the firmware?